A truly handy man.
Bob Jones posted an answer for this Black & Decker Mouse Sander/Polisher :
"Check Black & Decker's website for a recall on your mouse. The had one on my weed..."
Bob Jones posted an answer for this Fossil Watches:
"Believe me it was not really a gift! The amount of profit a Snap-On dealer makes on the..."
Bob Jones posted an answer for this Crosman Benjamin Sheridan 392 Air Rifle 685FPS 19"" Wood Pump 1 Single Shot BJ392 011482000709:
"Contact the authorized repair facility in your area. It is listed in the back of the..."
Bob Jones posted an answer for this Cars & Trucks:
"Torn boot lets in contamination such as water , dirt, and gravel and lets the high..."
Bob Jones posted an answer for this Televison & Video:
"Try either Amazon.com or Ebay.com. Type in a search for what you want someone will have..."
Bob Jones posted an answer for this Computers & Internet:
"I am pretty sure it will be the same as my Belkin WiFi router. Just unplug the power cable..."
Bob Jones posted an answer for this 2006 Suzuki Forenza:
"This is the factory warranty on your car you decide if it is coveredPowertrain warranty of..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"The owners manual is relatively worthless unless you just want one. I suggest going to..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"Could also mean the engine was massively flooded. Change the oil immediately, The gas..."
Bob Jones posted an answer for this Keurig Elite B40 Coffee Maker:
"I would contact Keurig.com It sounds like a posssible control board problem."
Bob Jones posted an answer for this Black and Decker USA RP250 10 Amp VS Plunge Router:
"Try rockler.com. They should have what you want."
Bob Jones wrote a tip for AnswersThatWork The Ultimate Troubleshooter:
"I take either detailed pictures or even video of the disassembly process that is the start..."
Bob Jones posted an answer for this 1997 Eagle Talon:
"Check your ignition timing sounds like it may be retarded a bit. Also could be a problem..."
Bob Jones posted an answer for this 1991 Eagle Talon:
"It sounds like a clutch related problem. I don't believe it's the actual clutch though . I..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"It's actually supposed to be a radiator symbolized. Meaning a problem with the coolant..."
Bob Jones posted an answer for this 1996 Eagle Talon:
"The inflation pressure should be on a sticker located on the end of the driver door. As..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"Eagle Talon, Mitsubishi Eclipse and the Plymouth Laser are all the same mechanically."
Bob Jones posted an answer for this 1992 Eagle Talon:
"You don't adjust valves on a 4G63 2.0 16 valve DOHC motor. It has hydraulic valve lifters."
Bob Jones posted a question about 1992 Eagle Talon:
"I have twice had my car drive home and not start the next day. It just cranks over. When..."
Bob Jones posted an answer for this 1991 Eagle Talon:
"You will probably have 15 0f the 16 valves bent. Make sure you hold the rear camshaft in ..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"On the passenger side of the transmission. Just above axle level, there is a plug with..."
Bob Jones posted an answer for this 1992 Eagle Talon:
"Do not remove the console sides as another poster suggests. It is not necessary and..."
Bob Jones posted an answer for this Keurig B70 Coffee Maker:
"Do not send it to them. The guy that suggested this is totally wrong! They will not accept..."
Bob Jones posted an answer for this Keurig Coffee Makers & Espresso Machines:
"Remove, then replace the water reservoir. Fill to full line with filtered or bottled..."
Bob Jones posted an answer for this Keurig B70 Coffee Maker:
"Remove, then replace the water reservoir. Fill to full line with filtered or bottled..."
Bob Jones posted an answer for this Keurig Special Edition B60 Coffee Maker:
"Remove the water reservoir, then reinstall it to it's normal position. Refill or top off..."
Bob Jones posted an answer for this Keurig Elite B40 Coffee Maker:
"According to my Platinum manual your exit needle may be partially plugged clean carefully..."
Bob Jones posted an answer for this Keurig Platinum B70 Coffee Maker:
"Remove the water reservoir, then reinstall it to it's normal position. Refill or top off..."