Moyer Diebel Dishwashers - Popular Questions, Answers, Tips & Manuals
How do I fix a door that wont stay closed?
The spring probably broke in the latch, or the door balance springs are slack. You have to pull it out and removed the side panels. The latch literally just holds it in place. You should be able to tell if the springs are holding the weight of the door though. Then split the door to inspect the latch.
We have a 301HT and the door is not staying at the
The manual will show a bushing under the adjusting nut at door frame opening that holds the door from dropping too far. This bushing usually breaks and disintegrates. Bushing is just over 1" long. Check both bushings on each side of door opening of machine.
No heat in 501 LT
There's only 2 wires doesn't matter which goes where. Check the hi-limit (small round disk) push the button with power off. You'll feel Click if it needed resetting
The dishwasher wont get up
possibly the temperature high limit switch needs resetting, by pushing the centre button in with your finger. Make sure power is off first.
Hi...where do you put the
If the machine still has a detergent pump, then the hose could still be taped to the back of the machine, half way up on the outside. It would have a label on it that says detergent. If the pump is missing then use a commercial grade powder detergent if your health inspector allows it. You would have to put in approx. 1 tablespoonfull each load.
I am at a romote
I would check the drain valve for fault.. Sounds like the drain valve is not closing this would cause the machine to drain whenever the motor is on.
Model MD 1000 LT D0804708
Purchased in August
If you are using a chemical supplier, then they might be able to check and possibly fix for free, parts extra of course. Contacting moyer diebel or whoever sold you the machine will tell you of an authorized service repairman for your machine.
J have a moyer diebel
Hello there
The 500HT machine is very old one. Turn off the power first. To get to the elements you have to get the control box off first so you can get to take off the elements cover , now you can see the elements.
If the system have been wired wrong and short circuit it. the temperature control may have to be change too. I would change the two elements and the temperature control and the hi ltd control all together at the same time so you know that system have no problem anymore. All the best Dickson
Model# 501 ht mb
HHH
Possibly the booster thermostat needs replacing. Expansion of the water in booster enters the wash tank when boiling showing HHH on both displays.
Not finding what you are looking for?