Balboa Instruments Pool & Spa - Page 2 - Recent Questions, Troubleshooting & Support
Need a schematic for this board
youll have to make one
schematics went out in the 90s
its like it dont matta anymore
no warranty no manuals or schematics an no parts
you throw it away or become a electronic hacker
5/4/2015 12:37:39 PM •
Balboa...
•
Answered
on May 04, 2015
Power tripping
the heating element is drawing a load when it shouldnt be. Make sure when u replaced the heat element that it isnt touching the metal tubing inside. Could possibly be a fault in the heating relay inside the circuit board
3/17/2014 7:17:16 PM •
Balboa...
•
Answered
on Mar 17, 2014
On my hot tub control panel Balboa M1 is the code Ec?
Your spa is in Economy Mode:Ecn or Ec MessageEcn or Ec MessageIf the Ecn or Ec Message is Alternating with the Water Temperature on the Display, the Spa is Operating in the Economy Heating Mode.If the Ecn or Ec Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Economy Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles.Ecn or Ec is Alternating with Temp:The Spa is Operating in the "Economy" (Ecn or Ec) Heating Mode.The Water Temperature is Sampled Only during Programmed Filter Cycles. The Heater will Only operate and Heat up to Set Temperature during the Filter Cycles. The Water Temperature will probably drop Below Set Temperature between Filter Cycles. Other Heating Modes are Standard, Standard in Economy, and Sleep Modes.Ecn or Ec is ON Solid (Not Flashing):The Current Water Temperature is "Unknown" (- - - or - -) while in Economy or Sleep Mode.Between Filter Cycles, while in the Economy or Sleep Heating Modes, the Pump has not turned ON and the Last Water Temperature is not Current. To read the Current Water Temperature, either Change to Standard Heating Mode or turn On the Heating Related Pump, and wait at least 2 Minutes.
11/30/2013 6:37:36 AM •
Balboa...
•
Answered
on Nov 30, 2013
Not finding what you are looking for?