...vss wire VEHICLE SPEEDOMETER SENSOR REMOVAL/INSTALLATION Disconnect the negative battery cable. Drain the transmission oil. Disconnect the vehicle speedometer sensor connector. Remove the vehicle ...
...is it the speed/abs sensor in the back axle vice versa.. speedometer started acting up and caused the abs system to disenguage... eratic speedo replace the vss....vehicle speed sensor on ...
...Sensor (VSS) clamp retaining bolt . . . . . . then pull the VSS sensor from the transfer case (4WD) or extension housing (2WD) Remove the speedometer cable and/or vehicle speed sensor from the ...
...this be the correct way to remove it? Thanks. TRY REMOVING THE AIR CLEANING ASSEMBLY SEE CAN YOU REMOVE THE VSS SENSOR FROM TOP OF THE TRANSMISION WORK FROM UNDER THE HOOD TO REMOVE THE VSS
sensor on a 1998 Mazda 626 where would it be located?You can find the vss by going under the car, on backside of transmission facing the floorboards. Right where the transmission mounts to the engine,
...SENSOR (VSS) REMOVAL/INSTALLATION Disconnect the negative battery cable.Disconnect the VSS connector.Remove the VSS.Apply ATF to a new O-ring and install it on a new VSS.Install the VSS. ...
...SENSOR (VSS) REMOVAL/INSTALLATION Disconnect the negative battery cable.Disconnect the VSS connector.Remove the VSS.Apply ATF to a new O-ring and install it on a new VSS.Install the VSS. ...
Question about 1998 Millenia
...sensor ( VSS) reports on the vehicle speed to the ECM, speedo and TCM the turbine speed sensor reports on the input shaft speed so that the TCM knows when to change ratios against the VSS reports the ...
Question about 1998 Millenia
...sensor.My speedo does not work.Making my tranny not shift right. Ichanged the vss.looking for a wiring diagram of that cirkit. Go to the link and look up the wiring for this system. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions