Questions & Answers for: Panasonic try guns

guns my technician took out the green gun because it was not working.He replaced the gun with another but it is not focusing on the screen.He does not have a service manual.how to get the gun to work?

...I can get to the service menu, but I'm supposing this is a hardware problem and there is no use trying to tweak it back into alignment. I know which end of a soldering iron to use, but due to

guns using my remote (as per the owner's manual). I have been able to realign the blue color to the target, but cannot get the red color aligned. I can move the red color "alignment cross" up and down

...chip?? This is most likely either bad connections on the convergence IC or a defective IC. Try resoldering the pins first. If that fails to resolve the problem, replace the IC. ...

We have a Panasonic CRT Television - TX-32PS11F The television makes a high pitch sound and the red LED is flashing rapidly when I tried to turn it on this morning. Nothing is showing on the screen? ...

How do you replace ic chips on Panasonic 52 inch hdtv projection? Most IC's on circuit boards these days are of the surface mount variety. You will need special Desoldering Equipment to remove these ...

..."convergence"...this will give you a "crosshairs pattern to align your "guns" ...it has three red, blue, and green.....try not to move the TV around too much....its knocking them out of ...

The "send" button does not always work. Could it be dirty? I takes a few tries to get it to send. the switch is worn out. If you're handy with a soldering gun you can pop the op panel apart, unplug ...

...Try watch a DVD movie,to make sure,if u have all three colors guns like R,G,B on the tv.If DVD movie have the same problems,than ur tv have a dying tv Tuner signal board,that take in the incomming ...

...try to watch a DVD also.The unit is around 5 yrs old, but in actual uasge, has less than 125 hrs run time. One of your color guns (Red, Green and Blue), have quit working correctly. It perhaps is the ...