...transmission torque converter seal, requires removal of trans...recommend replacing remain seal with it as it is already apart just requires flexplate removal. note that it is also possible that the ...
...transmission fluid leak on my 1998 Expedition is a seal that needs to be replaced by removing the transmission.Is it safe to keep driving until I can get it repaired? as long as you don`t let it run ...
...transmission on my 1998 ford expedition yOU MUST REMOVE THE SHEET METAL PAN FROM THE BOTTOM OF THE TRANSMISSION, INSIDE YOU WILL FIND THE FILTER, YOU WILL NEED A BIG DRAIN PAN TO CATCH THE 4 OR SO ...
1998 expedition eddie bauer 4 by 4 trans is slipping it goes in reverse but will not go forward I would start by checking the fluid level just to be sure it hasn't lost enough fluid so it can't engage
...transmission and (transfer case )if equipped to gain access to the flywheel. Once the tranny is out of the way you will be looking at the flywheel. If it is an automatic you will need to remove the ...
oil leak between engine and transmission relplace rear main seal, transmission must be removed in order to replace
...1998 Ford Expedition with a 5.4L ? There are plugs on both the driver's and passenger's side of the engine block and both cylinder heads [outboard side of each head]. There are also several ...
Question about 1998 Expedition
1998 for expedition 4.6 engine leaking water beteen the back of the motor and the transmission Not very likely, check the coolant passage between the cylinder heads. (The front part of the ...
Question about 1998 Expedition
1998-chrysler-voyager-transmission.html ------ Shift indicator directly goes to 2nd when key is turned ON? http://schematicsdiagram.blogspot.com/2011/12/shift-indicator-directly-goes-to-2nd.html -----
How to flush transmission on 1998 Ford Expedition remove transmission pan gasket and filter . Fill transmission fluid , do this 2 times .
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions