Questions & Answers for: Ford Explorer Sport Trac no speed control

Question about 2003 Explorer Sport Trac

1 Answer

...speed on a 2003 sport trac, 4.0 v6 when starting it goes up to about 2000 rpm then back to about 500 rpm, much to high? thanks tom you can't adjust the idle it's all done by the pcm.you might have a ...

Ad

Question about 2004 Explorer Sport Trac

2 Answers

...speed control no longer engages, could this be a fuse? This problem is most times caused by an open circuit in the rotating contact under the steering wheel, this part is called the clock-spring ...

Ad

...speed control and turn signals malfunction When the steering wheel is adjusted below the highest setting the break lights and turn signals do not work. The break lights will work if physical pressure ...

Question about 2006 Explorer Sport Trac

2 Answers

...loud, and feels like it gains power slowly, but there is no consistency to when it does this, low speeds, high speeds, in the middle or driving, from a dead start, no warning lights, no

Question about 2002 Explorer Sport Trac

1 Answer

engine stalls while driving 2002 sport trac 4.0 IT COULD BE FAULTY FUEL PUMP. OR IDLE SPEED CONTROL NOT WORKING.HAVE IT HOOK UP TO DIAGNOSTIC SCANNER TO CHECK FOR EGR PROBLEMS.

Question about 2003 Explorer Sport Trac

1 Answer

...Speed Control The speed control system is designed to maintain vehicle speed between 48 and 200 km/h (30 and 125 mph). Normally, when the brake pedal is applied, the speed control module deactivates ...

...speed. The fan switch gets power from a 40amp fuse and the control panel gets power from two other fuses. If you are working the control switch to get the fan to work, the control switch may be ...

Question about 2007 Explorer Sport Trac

1 Answer

...open or shorted, Ignition/Distributor engine speed sensor circuit poor electrical connection, Low battery charge, Faulty Engine Control Module (ECM) po446 try tightening the fuel cap if not replace ...

Question about 2007 Explorer Sport Trac

1 Answer

...speed (RPM) sensor circuit malfunction , EOBD code Fault location Probable cause P0446 Evaporative emission (EVAP) system, vent control - circuit malfunction Wiring, EVAP canister purge valve, ECM ...

...control is not activated. The instrument cluster illuminates the courtesy lamps when any door is open or ajar. The courtesy lamps shuts off when the doors are closed and the illuminated entry feature ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...