Questions & Answers for: Kenwood speaker repair

speaker you have. If it stays in protect, you should take it in for service. Unless you have the proper tools and experience working on electronics there is nothing you can do to repair this yourself.

repair. Look at the b speakers. Conect a speaker or two to the B position. If you have no sound than your surrond sound is ok and the unit is bad. Sound comes directly into the b speaker and not threw

sub woofer buzzes all the time, do I have to replace the speaker or can this be repaired? ur sub wont buzz due to bad speaker. either u have a faulty preamp or power amp. yes it can be repaired and ...

repair speaker surrounds (aka foam). Here's a link to one of them: http://www.speakerworks.com/speaker_repair_kits_s/65.htm Just a side note: repaired speakers will never sound the same. I repaired my

speaker output wires of the radio. Make sure all are intact, insulation is not chafed, stripped or otherwise damaged. Tape or repair when found. Double check the wiring (if this is a new installation)

...repair kenwood KFC-ws253 subs wires seem to be fried in from speaker wire terminal to cone. Hi there, This usually means the voice coils have burnt out also. When I was with Kenwood, it wasn't worth ...

...repair on this tuner but a simple test you can perform is to hook up another set of speakers or even just one different speaker. Test and if you get volume it is your speakers. Granted this is highly ...

Kenwood KR-V7080 receiver. No sound from rear speaker amp connections I have a Kenwood kr-v7080 receiver and a whole house sound system. I get no sound out of speakers connected to the rear speaker ...

...speaker configuration settings. It's recommended to contact Kenwood customer service or a professional technician for further assistance. It's important to follow the manufacturer's instructions and ...

...speaker output circuit. In this case, it may be necessary to take the receiver to a professional for repair or maintenance. If the B speakers on your Kenwood KR-V8010 receiver are not working while ...