Questions & Answers for: replacing intake manifold gasket

...intake manifold have coolant pasages. The lower intake manifold gasket will need to be replaced. There is an updated manifold gasket, manifold bolts, and torque specification. Call the chevrolet ...

...replacing the lower intake manifold & gaskets. A local repair garage has a complete kit which includes the intake manifold. I am also told that GM will reimburse some of the expense as this is a ...

intake manifold gasket / replace guide to replace intake gasket on 1998 olds bravaca 3.8L Engine NOTE The 3.8L (VIN K) non-supercharged engine uses a two-piece intake manifold consisting of an upper ...

...INTAKE MANIFOLD ON A LINCOLN HOW DO I REPLACE THE INTAKE MANIFOLD ON A 1999 LINCOLN TOWNCAR? answer , very carefully ... drain coolant , remove and mark all vacuum lines , make a schematic to diagram ...

...intake manifold gasket My 1996 land rover discovery is acting funny. It is driving fine, but the intake manifold gasket keep sweeling under the intake. What is causing this? oil from the pcv valve ...

...replacing the lower intake manifold, Remove or disconnect: Water outlet housing bolt and stud Water outlet housing Gasket and the thermostat. ECT sensor. Inspect the flatness of inlet flanges. Clean ...

...intake manifold gaskets. If you have inline (4-cylinder), the cause may be intake gaskets or bad or unhooked vacuum hoses attached to the intake manifold. Check all vacuum hoses for cracks or loose ...

...intake manifold supports.8. Remove support brackets at the intake manifold front corners and MTV.9. Loosen upper fastener attaching throttle body to support bracket.10. Remove clips attaching EGR ...

...intake manifold and manifold gasket. Disconnect the throttle body inlet duct from the engine. Twist off the radiator cap to allow draining of the coolant to flow more smoothly. Place an empty ...

...Intake Manifold Gasket? I must removed at least part of the intake manifold . Will I need a new Gasket ? If you have to remove the top half or plenum of the intake manifold, it is always recommended ...