Questions & Answers for: Ford Ranger replace clutch

...the fluid level in the clutch master cylinder and you will see that it will be empty. The problem is the trans has to be removed to replace it. Your clutch is blown dude & you need to get it

need clutch replacement directions for Ford Ranger need clutch replacement directions for 97 Ford Ranger XLT Manual 2.3 trans Remove drive shaft,remove crossmember under transmission.Remove ...

...cylinder is leaking. If yes the transmission will need removed to replace it. While you are there, check the clutch disc and pressure plate and replace as needed. Your clutch is out or

Clutch fingers may be broken. Replace clutch. Dude you broke the arm that connects the push rod (on the master cylinder) to the clutch pedal. I just did the same thing...the piece of junk is plastic!

...replace the clutch while you are doing this, since the labor is essentially the same. Once the clutch and replacement slave cylinder are reinstalled and the transmission is bolted back up to the ...

...that seem to match your limited description. 1. Clutch slave cylinder leaking and need to be replaced. 2. Clutch master cylinder has failed. RECOMENDATION: Have Clutch inspected and repaired ...

...a faulty clutch slave cylinder and/or clutch master cylinder. The best thing to do is have both replaced and be sure that they are properly bled of all air. If the clutch does slip then it will

...with no adjustment to the clutch performed by me. If the clutch is a manual clutch you might be able to adjust the cable. It yours is hydralic (and I think it is) you will have to replace the

...plate has been installed back to front and the clutch center is hitting the bolts that hold flywheel onto the crankshaft. If you have no not got a firm predal pressure replace the clutch master ...

...replace the clutch slave cylinder, you may need a proffesional. clutch pressior plate could be worn out.you said that you have to pump up the clutch, you might nee to bleed the clutch fluid res. and ...