...to Rx1. Your reading should be infinity(0). The last thing it would be is your element. Set on Rx1 remove one wire from your element and your reading should be 10 to 12 ohms. I hope I helped you
Question about DS-RX1 Compact Digital Photo Printer RX1
My DS-RX1 printer is totally jammed will not print and is making a load noise when TRYING to print? my dx rx1 ribbon alway broken
Question about DS-RX1 Compact Digital Photo Printer RX1
...RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or infinity. Turn the switch, and the reading should change from zero to infinity or infinity to zero. If ...
remove the leads. Again using the volt-ohm meter on RX1, check the terminals. If an infinity reading is displayed, it means that the fan has gone bad and requires replacement. 2) do-not heat Check the
Question about Tumble Dryer Heater/Thermostat (2957500600)
...RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or infinity. Turn the switch, and the reading should change from zero to infinity or infinity to zero. If ...
...RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or infinity. Turn the switch, and the reading should change from zero to infinity or infinity to zero. If ...
Question about DS-RX1 Compact Digital Photo Printer RX1
DNP RX1 photo printer won't work Error Light continuously blinks, the paper and ink are brand new and properly installed. can anyone help? Your flashing error light indicates either front cover open ...
Question about DS-RX1 Compact Digital Photo Printer RX1
DNP RX1 LOAD PAPER & INK CORRECTLY PAPER SEND OUT A FEW THEN THE PAPER JAM THIS IS HAPPENING CONTINUOUSLY I HAVE WASTE OVER 200 PAPER ANY HELP?NEW RIBBON AND PAPER USE AGAIN AND SAME PROBLEM Try ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions