Questions & Answers for: remove hold setting honeywell thermostat

...remove the round outer ring on the thermostat by pulling it straight off towards you. You will find 3 slotted head screws that hold the thermostat to the sub-base. These screws are located at the 3 ...

...Honeywell User Manual located at: http://www.bgesmartenergy.com/media/pr/thermostat-operation-manual.pdf Press System ? it will blinkPress & Hold Square 3 + 5 at the same time120 change with up ...

...? You have to click on the 'system' then hold the 3rd and 5th buttons on the bottom (about 5 seconds) then go down to 670, and setting 1. Repeat the process to remove lock, just change the setting to ...

...remove the set program on my honeywell thermostat . I want to operate it on a manual basis only. Hope you can help.....Thank you Just set the temperature you want and then press hold and this will ...

...hold the Pgm button. �� Insert a pointed object (e.g., paperclip) in the reset opening. Remove it when the thermostat's screen becomes blank. �� Wait one ...

...hold allow five minutes to go by.listen doen anything at all happen at unit. if nothing happens after five minutes remove sub-base from wall and at the thermostat jump with a wire the r terminal and ...

...that it's a programmable only tstat. You don't have an option to remove the programming. Hope this helps! Pressing the hold button will keep temp at desired setting. Run button returns to

remove the seven day schedule. If you select you desired mode (HEAT or COOL) using the SYSTEM button, then using the UP or DOWN arrows next to the screen to set your desired temperature, finally press

Honeywell non-programmable thermostat. LO appears in window I have tried removing batteries, checked functions 5 set for gas, and all wiring. Thermostat continues to show LO in small screen and will ...

...reset hole on the back that you see when you remove the thermostat from the base. If you use a pin point and push and hold it in for a few seconds ..the whole stat will revert to factory