Questions & Answers for: power remote door lock working

...Door trim Off, diconnect the Electric connector, Using a remote power supply connect that ,using the correct polarity, Pos to Pos....Neg to Neg, if you get no response, there is the problem. ...

...power locks; however anything using the key doesn't. To make matters worse the alarm engaged and I was unable to disable it, since the keyless remote wouldn't work. check battery connections ...

...door lock sticks in either up or down position when using the key remote. You posted this question in FixYa's "Car CD Changer" area. Please repost in an appropriate area so the proper experts can ...

...door lock sticking in up or down position when using key remote lock has gone out that means people have been pulling on the lock you need to take the door paniel off and look for a rod going too the ...

Door locks don't work on 2008 jeep liberty They don't lock or unlock and it blows a fuse every time I put one in. Probably a bad actuator in one of the doors.

remote turns on the lights and beeps the horn and opens the rear window but it won't lock/unlock the doors. The buttons on the door do not work either. The doors do not lock while I am driving

...door locks are working by remote 2010 jeep liberty do they work when using the master switch on the drivers door panel? if only the drivers door unlocks when pressing the button, it may be a personal ...

...fine. boot opens from button on remote, front doors will not open with remote. only rhf door opens with key 1. Replace battery in remote 2. Replace sensor at rhf door lock (it is inside of

...for you. If the battery in your remote went dead, it may work again by replacing the battery. There must be an unlock button inside? My 05 has power locks, button on the door. Unlocks the hatch

...door locks do not open using the remote. Is there a fuse that controls just the rear passenger doors? 2009 Jeep Liberty Did they work before? Possible causes apart from fuses and relays. Single press ...