Questions & Answers for: oil rocker arms push rod

...push rod had "fallen out" of rocker arm "cup"?Know what, like to know why? Everything "visible" -rocker arm, rocker shaft,valve springs- looks OK? Push rod not bent? Lifter problem? Any ...

...all push rods and rocker arm ports are not blocked however with the rocker covers off no oil shows on top. I let it run between 3 to 10 minutes still nothing. Sounds like a air leak somewhere to ...

engine tapping oil pressure is good and is full of oil If the tapping speeds up with the engine, ten to one it's a worn valve lifter, push rod, or rocker arm.

...Oil Supplement, or equivalent, lubricate the area of the rocker arm that the pivot contacts. Install rocker arms, pivots and bridge above each cylinder in their originally position (Fig. 23). (3) ...

rocker arm(s) over the push rods, then install the rocker arm seats. Tighten the rocker arm seat retaining bolts to 44 inch lbs. (5 Nm). Final-tighten the rocker arm retaining bolt(s) to 19-25 ft. lbs

...rocker arms wont pick up oil in 1969 357 chevrolet I'm not aware of a 357 engine in a '69 Chevy. I'll assume it's a 327. The rocker arms in that engine get their oil from the lifter ...

rocker arm....re assemble the engine parts using the proper gaskets...making sure everything is sealed...drain and replace oil.If the engine siezed up...then you have to get to serviced or replaced..I

...the two, the intakes of course are longer. The rocker arms should have been keep in order removed but they are the same for intake and exhaust valves. Torque to the rocker arms to 13 foot

...tick! Bad Lifter, Dirty Oil Deposits, Bent Push Rod, The rocker arms will make a noise if push rod clearance is not adjusted right. God-Bless! and hope this helps you!or the rocker arms may be

rattle oil, tools are available for that. Loosen rocker nut until you here tapping. Tighten nut until tapping stops. Then tighten 3/4 of a turn. It will run rough for a minute until the lifter adjusts