Questions & Answers for: noise axel

Question about 1987 Gl 4WD

1 Answer

...noise is back. im considering replacing the wheel bearing but until then does anyone have an idea of what else could cause this? Do you know if this car has ever been recked? if your going thru that ...

Ad

Question about 2007 F

1 Answer

...axel noise betwen acceleration and decelleration, is it bearings. that noise is not bearings but but incorrect ring and pinion gear mesh, this is caused by incorrect backlash of the gear set, once it ...

Ad

Question about 1997 Grand Cherokee

2 Answers

...noise in the rear axel. not sure which huming noise in the rear axel. not sure which side This Rear Axel Has A BAD Rep For Failure and Mostly Wheel Bearingd Go First ,Then By the time they go Its too ...

axel but the noise is I have a 2001 ford excursion and I had front end noise. I was guided to the hub bearing and I replaced hub on front axel but the noise is still there. Can it be in the front axel

...noise and I will eventually need to change the axle. What is your opinion? toyota uses lower quality axels like mazda so unless its under waranty you are looking at around 150.00 an axel..plus ...

noise that only shows up when the cv axel is in place, but not coming from the cv axel. I replaced the wheel bearing, and cv axel thinking they were the problem, but the noise is coning from the front

axel on both sides, refilled the ATF. The clicking noise is gone, but now I have this loud grinding noise that clunks. It happens at slow speeds in "Drive" and "Reverse" also when I turn. I only tried

...noise from front axel as i drive Not from the engine but from the front axel.. sounds like the cv joints have gone bad on axle, get underneath and grab the axle and see if it wiggles or moves. if its ...

noise is definitely coming from the front. I have used other scooters but i have no clue with this one. thanks Hi tighten the axel nuts if they r not tight they can sound like a clicking rubbing sound

Question about 2004 Alero

1 Answer

...axel for the side with noise. you must remove the axel from the hub, then pop it out of the tranny. best if the car is higher on the side you are taking the axel out of. then you will not loose all ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...