Question about 18V LXT Lithium - Ion Cordless Impact Driver Kit Model BTD140
Chuck won't tighten Can't get the chuck to tighten The chuck is held onto the drive shaft via screw located inside the chuck. The screw has reverse threads and sometimes the screw gets loose ...
Question about 18V LXT Lithium - Ion Cordless Impact Driver Kit Model BTD140
makita 6405 3/8 can you change the drill bit? how? according to my breakdown its a drill. do you checked if there is a screw inside the chuck. if there is one remove it by turning clockwise.open the ...
Question about Tools 18V 1/2" Lxt Lithium - Ion Hammer Driver - Drill Kit - BHP451
chuck on a makita DA39DA coredlesss right angle drill look inside the chuck for a screw. it will be a left handed screw.once you get the screw out put the chuck in a vice . you will need to squeeze it
Question about Tools 18V 1/2" Lxt Lithium - Ion Hammer Driver - Drill Kit - BHP451
chuck is broke , on my 18v makita cordless drill , how do i fix it Put the chuck key on and strike it with a hammer counter clockwise. the chuck key must be properly seated in the hole. Once the chuck
Question about BDF452HW Factory Reconditioned 18V Cordless Lxt Lithium Ion 1/2" Driver Drill Kit
...to remove chuck on makita bdf452 the chuck should open all the way then look down the old one attached to the drill there should be a screw near the end undo the screw and then it should come off
Question about Makita Bhp452 18v Lxt Lithiumion Cordless Hammer Drill
chuck on my makita will a dewalt xrp chuck work in my makita drill I answered that question already on another post, but if you need to know how to remove the chuck I have detailed instructions in the
Question about Tools 18V 1/2" Lxt Lithium - Ion Hammer Driver - Drill Kit - BHP451
...chuck of a 6408 makita electric drill Open the chuck and remove the screw inside the chuck (if fitted) the screw is left hand thread, fit the short end of the largest hex key that will fit into the ...
Question about 18V LXT Lithium Ion Cordless 3/8 Angle Drill Kit
how do you put the black chuck cover back on It sounds as thought you have a keyless chuck on your drill. The cover is not meant to come off. You will have to replace the chuck.
Question about 18 V LXT Lithium-Ion 7-1/2 In. Dual Slide Compound Miter Saw Bare Tool
keyless chuck stuck closed Try WD40 and let it soak then lightly tap the chuck with a screwdriver handle. Then try to release the chuck.
Question about 18 V LXT Lithium-Ion 7-1/2 In. Dual Slide Compound Miter Saw Bare Tool
is it the chuck or the clutch? Makita LXFD01Z 18V LXT Lithium-Ion Cordless 1/2" Driver-Drill Chuck just slips when I try to loosen it. problem with clutch
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions