...w/ torque specs for removal and instillation of front and rear tires on a 2006 kaw concours . all lube types and such Removal and installation of bike tires is not easy for the do-it-yourself non ...
...to be returning back to the original position and is stiff. Any ideas that could help? thanks! ' Lube the pivot
...a bit your cable may be frayed and not letting the cable move in the housing. PLUS you do need to lube the moven parts on your bike it will help more then you think Mark C.C. ...
Question about 2002 VN 1500 Vulcan Meanstreak
...Meanstreak 1500 with 17,000 miles. It runs great. The owner claimed the bike had been running dino lube in it from the get go. I am not sure if I should run 20/50 or 10/40, need help on that one. My ...
job you can't afford to make mistakes on, only to find out later the hard way, worse case would be an accident and you are injured.... I don't know what parts you have now, or how it was taken
...there should be a spring in the upper section near the grip and yet there isnt one, is this true Lube and adjust your cables, your throttle should snap back if properly adjusted and lubed, there
...job simple. The spot where it breaks off must have a tee there, right ? Start there until you get the size you need to have the right amount of vacum. Or you can plug the one that is giving you ...
...and lubricate the throttle tube and throttle cable with penetrating oil like WD40. To get the lube into the cable I use a finger from a rubber glove with a small hole in the tip, slip it over ...
Question about 1999 ZX-6R Ninja
...howdo i fix it to where i wont have to buy a hole new assembly? You can take the cable of and lube it with wd40 or silicone spray then reinstall. Your only solution is lots of lube. Pull cable ...
does a 2000 kawasaki 600 have transmission fluid no , it uses motor oil to cool and lube the clutchs and bands.
Usually answered in minutes!
239 Questions
197 Questions
175 Questions
157 Questions
126 Questions