Questions & Answers for: Honda XR 200 leveling the front

Honda XR200 2000 model over-heating Just replaced the piston/ring in this bike, it's over-heating & nips up can you offer some advice? re-strip top-end and remove scuffing marks from piston using 400#

theres alot of smoke coming out the exhaust pipe The bike runs fine but after you start it lots of smoke comes out the tailpipe when its idleing and when I ride around. Cant seem to figure out whats ...

how do i remove the front wheel of my honda 2000 xr200? i have removed the 4 screws and the plate on the right hand side fork but cant seem to remove the wheel from the break on the left side fork. is

i have an 1984 honda xl 200 3 wheeler and the deal that you have to take off to remove clutches. right next to it. with the three screws, and center nut behind it squirts oil when you press it. well ...

how do i check the oil level of front forks on a how do i check the oil level of front forks on a xr 200 2001 Dismantle the fork and look inside.You need to measure it to make sure it is in the ...

what kind of oil doi use and how much Mobil 1 20w-50 motorcycle oil with a JASO-MA rating is what i recommend...this is good oil. If you ride in a colder climate go with 10-40....1.1 litre is what the

tires not alignent solution for tire alingment hi there the best way to check is string and ruler .put the stringaround the front tyre then run it past each side of the back wheel [it is easier with ...

Honda xr 200, revving up and down during high rpm and higher speeds. Hi, I have a 1994 XR200, I got the bike from my older brother (hadn't been run in a few years), after changing fluids cleaning the ...

what is the hight of the float in the carb i replaced the carb kit i need the spec for float adjustement the gas comes out the over flow if the exact height is not known , a good rule of thumb , is to

just did a top end rebuild on my xr 200r 2001 and have alot of oil coming out of the exhaust pipe i just rebuilt the top end new piston and rings honed the cilinder im pretty sure i did it correctly ...