Questions & Answers for: leveling the front

Ad

Question about (MFI2568AEW) Bottom Freezer French Door Refrigerator

3 Answers

leveling refrigerator I just bought and took delivery of a Maytag MFI2568AEW refrigerator.It is out of level. The instruction manual says there should be 2 hex nuts on each side of the front brakes to

Ad

Question about MSD2656G Side by Side Refrigerator

1 Answer

leveling refrigerator I just bought and took delivery of a Maytag MFI2568AEW refrigerator.It is out of level. The instruction manual says there should be 2 hex nuts on each side of the front brakes to

Ad

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...leveling legs at the front and rear of the bottom of the machine. I find that having the front of the washer just slightly higher than the back of the unit is best for keeping the dispenser from ...

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...screws on the bottom front how you adjust it. Yes, the front two "feet" of the refrigerator are used to for leveling purposes. Don't forget to level front to back, and left to right. Hope this

Question about 1998 VZ 800 Marauder

3 Answers

I need to know the oil capacity of the front forks on my 1999 Suzuki Marauder VZ800. FORK OIL ? Place the front fork vertically without spring. ? Compress it fully. ? Pour specified front fork oil up ...

Question about LDS4821WW 24 in. Built-in Dishwasher

1 Answer

Bottom drawer does not have a hard stop. Drawer will roll right off the door and on to the floor check the level of the Dw per the instructions.. may need to raise the front up... If you take the ...

Question about Electric WCVH6800J Front Load Washer

1 Answer

...leveling feet on the rear of the machine and adjustable feet on the front of the machine. Material needed to carry out the function. Level,Another person,Wooden block or brick,14 mm wrench Unplug the ...

Question about WSXH208A Front Load Washer

1 Answer

front to back, and side to side. It is also essential to have good pressure on all of the leveling feet of the machine. Any side to side motion of the machine will be magnified if the feet don't share

Question about WSXH208A Front Load Washer

1 Answer

while on rinse cycle. the machine make a loud of noise, the whole machine shake alot. i replace all the 3 spring, and one spring on the back. and notice there is 2 pin that drop. so i re scure the pin

Question about WSXH208A Front Load Washer

1 Answer

middle. Then, placing the level front to back, adjust the front only leveling legs to where the bubble in the level is only half showing in the middle. This will allow the doors to close by themselves

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Brad Brown

Level 3 Expert

19163 Answers

john h

Level 3 Expert

28114 Answers

Are you a Refrigerators Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...