Questions & Answers for: Chevrolet C2500 large windows

Question about Chevrolet C2500

1 Answer

Starter installation How do I install High Performance Starter to a 1966 chevy pickup ignition. large wire on big stud of starter for full time power and the little stud will be where the wire from ...

Ad

...tranny pan gasaket and filter 82 diesel chevy suburban 6.2l Remove All Bolts at Rear of Pan With LARGE DRAIN PAN Under to catch old Trans FLUID. Then Loosen Equally The Remaining bolts ON THE

Ad

Power windows and Locks don't work I have a 1988 2500 Silverado which the power windows nor power locks work on either door. I have power at least to the plug connections for the windows motor but ...

Question about 1999 C2500

2 Answers

Power window malfunction Driver side power window assembly seems to work ok except it spits the large gear out of the smaller one at the top. How do I fix. This is on a 1999 chevy c2500 pickup you ...

...get a rust ring built up inside that drags on the brake shoes when you try to remove it. I use a large ball pein hammer and strike between the lug studs to free it up, and then use large screw ...

in place.usually 15 mm socket. there is a small nut holding wire. 5/16 or 11/32 socket.. remove it. large nut usually 13mm socket. once removed just reverse procedure. leave comment if successful

...solenoid. You can do this with a test light or a voltmeter. Check to see if there are 12v + at the large red wire going into the starter solenoid (engine off key off). If you have no voltage, then ...

Question about 1998 C2500

2 Answers

...pinion shaft that drives the gears inside the differential. This flange is held to the shaft by a large nut threaded onto the pinion shaft. On the flange there is a machined surface the seal rides ...

Question about 1998 C2500

2 Answers

...(remember the E as it is different than the 4L60). It will have a square pan with 16 bolts and a large connector with many wires (20 if I remember right) on the right side. The 4L60 (earlier known ...

...starter relay removed from the fuse box, and without the key in the ignition. I disconnected the Large positive cable from the starter and then connected the cables to the battery and left them ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...