Questions & Answers for: knock sensor 2000 nissan altima

Question about 2000 Altima

1 Answer

...knock sensor and thermostat in. We are still getting a thernostat reading that the engine is too cold. We also did not pass the e-check and had to get a waiver. We failed the NO portion only. Any ...

Ad

...knock) the sensor of each wheel just a little not to hard and see what happening after each wheel. I think its the position of the sensor move every 3 or 6 month and need to be replace because of the ...

Ad

...knock sensor is on a 2000 Nissan Altima under the intake manifold(rear of the engine). To access, the manifold must be removed. You may also see it from under the vehicle, at the rear of the engine, ...

...what to do,change oxygen sensor or knock sensor I would start with the o2 sensor first if its not working right it will set off the knock sensor but beware of vaccum leaks sounds like your running ...

have already replaced the 02 sensor and the knock sensor could it be that i need a cataylic convertor in the front or is s sensor that needs to be replaced the code indicates the converter is worn out

...of knock sensor? The knock sensor is located on the back side of the engine(side closest to firewall)below the intake manifold bolted to the block.Looking from the bottom its above the oil

...knock sensor malfunction code. Check engine light is on.99 altima. Should I do it, my sticker has 11 months left. Will I do damage if I ignore and what will I be getting myself into if I fix it. ...

Question about 2000 Altima

1 Answer

Knock Sensor (Nissan Altima 2000 GXE picture of where it is located. it is very simple. if you lay down underneath the car and look up at the oil filter it is just above the oil filter. you should be ...

knock sensor for 2005 nissan altima 2.5 for the crank its tward the front of the engine in the head has two wires unplug them and spray the sensor with penetrating oil before removing or it will break

...knock sensor malfunction. p0303 and p0325 - i can see these working together, if a cylinder misfires, it will cause the knock sensor to trip. I would lean towards the coil and or ignition module, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...