6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern
heater blower only runs on high your blower resistor is bad Blower motor resistor unit is located under the dash on the passenger side on my 2001 (on earlier years it might be inside the dash accessed
Question about 1999 Durango
...torque settings for 99 dodge durango head bolts & intake bo manual gives in. lbs,what is the equal in foot lbs.,i do not have a in. lb.torque wrench Here's a link to a conversion ...
...intake manifold plenum pan gasket may be drawing oil from lifter valley of engine..remove air cleaner and check down inside manifold with throttle plates wide open and look for oil pooling inside ...
...all intake manifold gaskets and plenum gasket. If this does not confirm intake leak , have the Throttle Body cleaned manually by a professional, or yourself using specifically" Throttle Body Cleaner
Question about 2001 Durango
...intake manifold. Check MAP sensor O-ring seal for cuts or tears. Position sensor into manifold. Install MAP sensor mounting bolts (screws). Tighten screws to 3 Nm (25 inch lbs..) torque. Connect ...
intake manifold bolts. Torque to: 200 inch lbs. (23 Nm) Upper radiator hose to thermostat housing Alternator (A/C Vehicles) Torque to: 30 ft. lbs. (41 Nm) Support bracket Torque to: 40 ft. lbs. (54 Nm
...Torque to: 21 ft. lbs. (28 Nm) Intake manifold and throttle body assembly Exhaust manifolds Spark plugs Torque to: 30 ft. lbs. (41 Nm) Coil wires Coolant temperature sending unit wire Fuel injector ...
...intake plenum gasket! The intake manifold has a steel plate bolted onto the bottom of it with a gasket called a plenum. This plate is inside the lifter valley. If this gasket fails it will cause a ...
...intake manifold. Tighten bolt. Refer to Torque Specifications. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque ...
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions