Questions & Answers for: indoor unit fan

Question about 24R1 Air Conditioner

1 Answer

not running. Check to make sure the outdoor unit is operating. If the outdoor fan is running but there is no indoor fan after 5 mins then you must likely have a gas issue or a fault compressor circuit

Ad

Question about 24R1 Air Conditioner

1 Answer

...code number 19 (indoor motor fan machine look) but I dont know how to delete this recorded code. Indoor unit fan mechanism locked. Check your indoor fan motor for bearing replacement or new

Ad

Question about 24R1 Air Conditioner

2 Answers

...indoor unit. If nothing is running, check to make sure all panels are on inside, and that you have electricity to the indoor unit. Some air handlers and furnaces are equipped with a safety switch on ...

Question about 24R1 Air Conditioner

1 Answer

...unit(model # mh080fxca4a) and two indoor 18000btu indoor units(model #mh052fnca). What would be the output of the outdoor unit? The contractor said this outdoor unit using only two of the four ports ...

Question about 24R1 Air Conditioner

1 Answer

...indoor unit fan should start blowing cold air immediately and then turn off once the room temp drops one degree below the cooling temp setting. If the indoor unit does cycle off, check the outdoor ...

indoor unit and removal of the electronic box cover. The indoor board is in there. The fuse may be replaceable or it may be a type that is soldered on which makes it virtually non replaceable. ( A new

Question about Electronic Programmable Heat/Cool Thermostat - CT3300A100 Heater

1 Answer

...indoor unit. It connects to a low voltage control panel in the outdoor unit that sends a signal to your indoor fan/evaporator. This wire is called the fan relay switch and physically runs between the ...

Question about Electronic Programmable Heat/Cool Thermostat - CT3300A100 Heater

1 Answer

Indoor unit indicator RUN lamp = 6 time flash TIMER lamp = Comes on Outdoor unit indicator (LED5) = Stays off Description of trouble = Indoor fan motor error (2) Cause = Defective fan motor, Connector

indoor unit. Put red green and yellow wires together behind the tstat with a wire nut. That is power (red), indoor fan (green), and compressor (yellow.) Turn power back on. This is bypassing the tstat

Question about Electronic Programmable Heat/Cool Thermostat - CT3300A100 Heater

1 Answer

...indoor unit is not supposed to turn off when the indoor Temp reaches the set temperature, but the indoor ambient sensor tells the outdoor unit that that's enough. Then, the outdoor unit minimizes the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Heating & Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...