hole, and note that the back plate of the motor housing clips into the gear housing cover, and that if this is not properly reinstialled, your speed control won't work. The total time to dismantle the
...punch to drive it home. If that doesn?t seat it permanently, then you need to replace the groove pin, or if the pin hole is too loose, then the whole agitator shaft assembly Do you have the Parts ...
Question about K45SS Classic Stand Mixer
...hole on the agitator shaft. The end of the groove pin should be flush (or very nearly flush) with exterior of the agitator shaft. If there is a significant space then the groove pin has started to ...
...punch in the hole whack it in the same direction it turns when the motor is running. That will eventually unscrew the coupling and you will be able to screw the new one on. There is no need to make a ...
...turns with the motor. Drill a hole in that top flange, engage a punch or screwdriver into the hole and hit it in the correct direction with a largish hammer. If you do it right it takes 1 to 4
Question about KITCHEN AID 5 Quart Artisan Series Stand Mixer
...into the commutator that the brushes run against when the motor is running. Once you have your hole drilled you can try and extract it with a hooked pick type tool or with a vacuum cleaner ...
Question about KITCHEN AID 5 Quart Artisan Series Stand Mixer
...hole and whack the punch with a decent hammer to shock the coupling in the direction it normally will be turning. Sometimes it's a few whacks, sometimes a whole lot more but eventually they always ...
Usually answered in minutes!
493 Questions
357 Questions
285 Questions
205 Questions
183 Questions