Questions & Answers for: Ford Ranger high pitch noise

...starter? Did you put the starter straight? Did you lock the screw evenly? where this noise from?You mentioned the noise like high pitch grinding noise, is it from the starter area or flying

High pitch noise when turn key to start / engine not turning over 1997 ford ranger 4x4 2.3 V6 / Truck started fine this morning / temperature below freezing / tried starting a few hours ago and only ...

high pitch squeel . only happens when moving forward slowly,( 12 to 30 mph ), the breaks were checked and are fine. It doesn't change when I rev the engine.or change pitch when I brake. when I come to

...high pitch squeal (Just like the noise made when you turn the ignition when the engine is running) I had ti get under the van and move the crank slightly for the starter to engage. when i drove no ...

...high pitch when i turn left, Do you know what it is ? the grinding sound and the high pitch sound may not be related. the grinding in the brakes means it is time to replace the brake pads / shoes and ...

...high pitch squeal coming from around the evaporator case, but could not find any vacuum leaks. I replaced plugs, wires, and have cleaned out the IAC of any carbon. The problem is still there. I am ...

...high pitch noise. It doesn't sound super bad. It starts out quite and gets louder. If i stop accelerating it stops immediately, but starts doing it again after a bit. I also have a second ...

...high pitched squealing noise akin to a slipping drive belt ,which only occurs under load not at idle. no fault codes no excessive smoke from exhaust no vaccum leaks .noise goes only appears under ...

...high-pitched grinding sound that only occurs when it's moving. It's always loudest in the morning, when the car is cold. I've replaced the brakes and also had the replacement brakes inspected by two ...

high pitch noise under hood 2003 ford ranger when excelarating Vacuum leak around inlet manifold or hose, spray around with D 40 or similar,engine will speed up when you find the leak. DO NOT spray ...