Questions & Answers for: gas 1998 mustang

...mustang will start, but then immediately cuts off. I had the same problem a couple weeks ago, but then it seemed to run fine. Now the problem has come up again. try to keep it running by keeping your ...

Ad

...1998 Ford Mustang GT? Left hand side (if facing it), behind distributor, above oil fill. here is a picture I got a 2002 gt mustang with a 4.6... when I switch from 1st to 2nd it's good. 3rd gear I ...

Ad

...1998 ford mustang v6 3.8l .. is hard to start for first start of day i have to keep cycling the key and cranking on it , seems like fuel but is not i replaced fuel pump , fuel filter, fuel pressure ...

...mustang v6 starts fine but when put in gear it stalls out ??? Change fuel filters. You may have to drain and clean the gas tank. Over a period of time, debris accumulates in the bottom of gas tanks. ...

1998 Ford Mustang - No power to AC compressor Check fuse and also low pressure switch located in engine bay at the ac hose close to the wall passenger side. If low gas safety will not allow compressor

Question about 1998 Mustang

1 Answer

1998 ford mustang with the 3.8 liter v-6 engine will not start. Battery is good. engine turns over and it has barely started but would not continue running. put some heet into the gas tank because the

1998 ford mustang check engine light go to Advanced Auto or any other parts store, they will usually read the codes for free.  Without a code reader, you can not troubleshoot the code. if you buy

1998 ford Mustang, run/drive just fine for about 1 hr turned it off, then would not start, it turns over but not start. Changed the fuel line filter by gas tank--. Set over night---started and ran for

1998 ford mustang fuel filler neck grommet wont fit I have purchased 2 filler neck grommets 1 from Napa and 1 from Ford. Both are about 1/4" to large to fit into the hole of the fuel tank. From whats ...

1998 mustang read full all the time? Why does the Gas gauge reads full all the time even when the car is shut off for hours? Definitely a issue with the gauge, or the wiring for the gauge. Sounds like

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...