Questions & Answers for: expansion control valve

...expansion valve. It uses a fixed orifice tube in the line. They seldom go bad (get plugged). What are your symptoms that make you think you have a bad orifice? The a/c system compressor should cycle ...

expansion tank as the releif valve is the final safety device on a water heater is of great concern the temp control gas valve or high limit are supposed to shut unit done long before the safety limit

...EXPANSION VALVE FFOR THE S/C ON THE HONDA 2008 crv? most of the time the thermal expansion valve(TEV) is located in the evaparator case (on passenger side under dash or behind glove box) the valve ...

...control device. Some expansion valves are wrapped with insulation. When the sensing bulb is in the evaporator case, it does not need to be wrapped because it stays cold. When an expansion valve is ...

) Discharge air conditioning. 2.) Remove dashboard 3.) Replace expansion valve. ive never seen an expansion valve in an rx8 go..... usually its the climate control head. The blend knob stops working..

...King 10PJH1801 is not working It,s not heating it may not be the expansion valve. when they fail it usually loses charge in the bulb capillary. lack of heat should be reversing valve or control ...

...expansion valve (TX ) valve is located on the inlet side of the evaporator under the dash it is what controls the rate at which liquid is allowed to escape to turn to gas and so cause the cooling ...

...valve is always located at the entrance to the evaporator coil in all systems, freezer A/C or whatever. The control bulb for the expansion valve is located at the outlet of the evaporator

It's blowing cold air whilst on heating mode I think expansion valve does not working that's why its not switching . need to check control supply for valve or if its OK need to replace expansion valve

...used a thermostatic controlled expansion valve not an orifice tube. ...