Questions & Answers for: dryer heating element stays few

...dryer model# ler5636eqo the problem, the heating element turns on for 18 seconds then turns of. It does tis on any setting except cool down, then it runs for 1-2 minutes then the heat turns back on ...

...heating so now I have wet clothes. The dryer kept running through the cycle, the time kept going down and everything else seemed to be working fine. Not sure of the model as I can't find that any ...

...dryer. If yes, the element has a short and therefore always stays on. Replace it. If no, run the dryer for a few minutes and listen for the clicking of the relay which cycles the element. If there is ...

...heating element. It all turns red. Once you start the dryer in turns few for a few seconds and then goes out it will come back on but just for a few more seconds. I removed the wires from the high ...

...dryer from heating properly. Next, press and hold the My Cycles and Back buttons together for a few seconds. this will enter you into the service mode for the dryer and, will report any problems. To ...

...heating problem is not a lint build up in the discharge hose or the dryer,as this condition can cause heater/thermistor problems such as overheating of the heating coil leading to failure of the coil ...

...Dryer no heat: or shuts down soon after heating CHECK: Thermal Fuse If the air flow in the dryer is restricted, the temperature in the heating chamber can get hot enough to blow the thermal fuse. If ...

...Dryer no heat: or shuts down soon after heating CHECK: Thermal Fuse If the air flow in the dryer is restricted, the temperature in the heating chamber can get hot enough to blow the thermal fuse. If ...

...Dryer no heat: or shuts down soon after heating CHECK: Thermal Fuse If the air flow in the dryer is restricted, the temperature in the heating chamber can get hot enough to blow the thermal fuse. If ...

...dryer gets old. When this happens, the igniter glows, but gas never enters the heating chamber or does not stay consistant. Performing a continuity test on either part will help you determine whether ...