...Open the printer, pull out the drum kit, place the drum kit in a dark place, use a vacuum cleaner and a brush and wipeout all dusk, but be carefuly cleaning it.At could be a sensor that are
...dirty charging section - for the drum to pick up the toner it must be charged electrically prior to exposure - if the charge grid is not clean then it will not give the drum an even charge - not sure ...
...remains teh same "Message in Memory/check drum cartridge" You need to clean the drum surface as well the charger roller. Removing the paper jammed can caused the surface get the dirty by toner
dirty from something or the silicone gasket strip that removes the toner from it is "leaking". Remember that the green drum is very delicate and should not be exposed to light for a prolonged time. If
...drum unit, or the ones inside the printer, get dirty and have poor electrical contact, giving this kind of message. Try to reseat the toner cartridge in the drum, clean the contacts and re-insert the ...
...dirty drum or a dirty drum knife block (very likely, some dust accumulated there). Rollers may be cleaned with rubber-safe cleaning fluid or isopropyl alcohol (in a pinch, common denatured alcohol ...
Question about C3400N Single Pass Color Printer
...must look at the LED Printer heads. Below is the bad print-out: :After following the steps that we suggest, we found the LED head above the red drum is dirty. Below is the picture after it is
Question about C9600hdn Laser Printer
dirty. (Figure 7-2 ) • Has the image drum been exposed to external light for a long time? YES Replace I/D Unit. • NO Is the fuser unit roller dirty? YES Replace the fuser unit. • NO Correct the [Paper
...dirty led head use a wet towel and clean it it is located usualy on the bottom site of the upper cover right above the drum. The second thing that can be if you are facing lines on every print that ...
Question about C5500n Laser Printer
drum should be easy enough, the photoreceptor may be simply dirty if it's not had a service for a while, if you know where they are, give them a wipe with a cloth or cleaning pad with Isoproyl Alcohol
Usually answered in minutes!
259 Questions
172 Questions
152 Questions
147 Questions
126 Questions