Questions & Answers for: dim low beam lights olds

...low beam are very dim. Any idea?? I would think ur low beams are burnt (the bulbs) because that dim light u see should be the daytime running lights, which are usually less bright that the lights ...

...low beam but dim. The other side only high beam works. What could be wrong. https://s1.postimg.org/1i7q5btlu7/headlamps.jpg Click on the link. The top wires to headlamp are voltage for hi or lo ...

...low beam are very dim. i can see that the bulbs are on but they are not bright at all and i already replaced both bulb assemblys. drivers side works fine The ground wire to that side has been ...

...a fuse or relay I can check or replace today? yes there is but it is probably da bulbs My 99 olds alero. The low beam don't work. Replaced bulb still don't work. High beams work. What else could it ...

...low beams are very dim while driving at night, but high beams work fine. The low beams seem to be running on daytime running lights. Shouldn't the dim lights be brighter then the daytime running ...

...low beam. When the low beams are good, the high beams are too high, when the high beams are good, the low beams are too low. Am I missing something here? Unless a car has been in an accident it is ...

...dim lower than low beams. - I replaced both bulbs with no change The wiring harnesses in the plugs behind the bulbs are burned up seperate rear of headlight cover and inspect parts available at your ...

...dim low beams and no hi beam - Subaru Outback ... www.subaruoutback.org > ... > General > Electrical & Electronics Oct 11, 2014 - Hi everyone, My drivers side headlights are dim on low, (car has ...

...dim on low beam and goes out when on high ... ? one headlight dimmer than the other - Subaru Legacy Forums ... legacygt.com > ... > Fourth Generation Legacy (2005 - 2009) Nov 18, 2010 - 15 posts the ...

on my high beam headlights work good it just the left high beam stays on a dim light while on low but when on high they work good It could be driving lights mode instead of low beam. Check connections