Questions & Answers for: dayton heater sensor

replacement parts need to buy flame sensor Dayton was made by Desa. desaint.com has parts or run search for reddy heater parts the photo cell should be the same.

...Dayton gas furnace will cycle just fine and then all of the sudden it will quit. When I reset it, it will normally run fine for awhile. I have watched it a few times when it locks up on me and it ...

...2-3 times then it will shut off. Getting no heat. Its a Dayton Model # FG8807S12MU11A Amazing how just a little bit of dust will stop these things cold. Try cleaning the pilot sensor if they have

Dayton Model 3E219 Heater - weak fire to ignitor I have replaced the ignitor (spark) plug and checked for worn wiring. I am getting a weak spark and the kerosene will not ignite. Could it be the wire ...

...Dayton heater m#3e3665 when reaches temp. fan Have 30,000 btu Dayton Fuel Trimmer hanging garage haeter model #3e3665 when reaches temp. fan turns off but burners don't. Tap with dammer everything ...

...heater is not proving the flame...and shutting down on safety... Check the flame sensor and all connections of the ground from the burner to the ignition control... The control may also be bad... for ...

Dayton hanging gas heater that the fan comes on intermittently. The flame will shut down and try again, then the fan will come on. This problem is caused by a bad flame sensor (looks like a spark plug

...dayton 3E132 infrared heater,will light but runs for a while and shuts down,also do you need it hooked up to a thermostat Yes, it should be hooked to a millivolt wall thermostat. Doing that should ...

...dayton gas heater model 3e469 wont stay lit chech the flame sensor or thermocouple which ever it is equipt with. Sensors can be cleaned by lightly sanding them and therocoulpe's need to be ...

Dayton heater lites up and runs for about ten seconds and shuts down red light flashes don't know what the light is for either Most likely the flame sensor is dirty and needs to be cleaned. The sensor