...Make sure you set the CS or master/slave jumpers to match the original. Don't add a drive that draws too much current or you can overtax the power supply. Check the 5/12v draws on the original. ...
...5 sets of pins Many thanks look for the mark at the top, MA for master, SL - slave, CS - cable select, these three are main connection for IDE designation using the plastic jumper, just follow where ...
...5) BOOT Failure Insert BOOT Diskette into Drive A: Press any key when ready. (I don't have a boot disk, so I press any key anyway.) Searching for BOOT record from floppy..Not Found Searching for BOOT ...
...5 days ago, I'll presume you still (and if not, then someone else will) need the answer ... Virtually all Maxtor drives adhere to the following general rules concerning jumper settings (at least up ...
Question about Hard Drive
CS is Cable Select) Sometimes it's right on the edge, where the 40 pin flat ribbon cable plugs in. It will be letters raised in the plastic, of the harddrive body. To find where to set the jumpers for
CS. The EIDE Western Digital 10.2GB harddrive? Same setting as for all of Western Digital's IDE harddrives. (EIDE is WD's version change of IDE. Enhanced IDE) View the harddrive from the back, and the
...CS btw). 4. If it?s an 80 pin cable, replace it anyways. 5. Check the system event log for other errors & research them. ?This lead me to find a error while paging operation was taking place on ...
CS on IDE1 Your computer and bios are new enough to support most of todays drives up to 1.5 TB Some versions of that computer also use SATA. if it is a SATA drive then make sure SATA is enabled in the
...5 and 6 - second from the left relative ). Master puts the jumper vertically on the left most pins (7 and 8). Slave puts the jumper on the top right (horizontal) over a missing pin and the adjacent ...
...5 of them on my shooting range...So thanks in advance for any kind of help... Hello Looking at the specs for this unit, I think I have a solution for you. The hard drive is SATA but the optical drive ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions