Question about AEW4530DDS Electric Single Oven
...control pad starts beeping, and I have had an error code F1, and others. I have replaced this panel once before. I saw an internet site that said it was the control pad being mounted to closely ...
...on the oven door. I had my range serviced and when the door does not close all the way, then the hot air rises and basically cooks the control pad. I just posted too with my frustration on this
Question about ARGS7650SS Gas Kitchen Range
...up top igniter are working fine electronic key pad does not lite up top burneringniters are working 1.Loose wire to control board 2. Defective control board 3. This requires interactive ...
Question about ARGS7650SS Gas Kitchen Range
...code reappears then replace the touch pad, or touch pad and control board (clock) if all one assembly. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE
Question about AP077R Portable Air Conditioner
...pad and the remote control PCB out of the cover. carefully using a good cloth clean the PCB and the carbon dots under the pad. if you happen to see any maiture/ sweat tugged inside, use a hair dryer ...
Control or Clock) or the touch pad is defective when F1 error code is present. Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary.
Question about ACS7270AS Electric Kitchen Range
Control or Clock) or the touch pad is defective when F1 error code is present. Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary.
pad on the electronic control is bad and needs to be replaced. This is an easy fix but the parts might be on back order and run around $75. Not as bad as the electronic control which runs around $250.
Question about AER5515QA Electric Kitchen Range
Control or Clock) or the touch pad is defective when F1 error code is present. Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary.
Question about MVH230 Microwave Oven
...pad control impulse to come in. If there is no trigger voltage to the mP this can be the control pad problem. The mP must be checked for the working voltage and also the frequency oscillation at the ...
Usually answered in minutes!
59 Questions
34 Questions
28 Questions
21 Questions
24 Questions