Questions & Answers for: cause heating 2000 maxima

...cause this? I would appreciate any input. I have a 2000 nissan maxima gle and all of a sudden it will only drive in reverse and third gear (failsafe mode) i assume....but there is no check engine ...

cause of this is. I have a 2001 maxima GLE with 243,000 miles on it. blower moter.... all speeds ????? auto a/c or manual????turn the blower on and rap on it. if it starts working , it will need to be

...2000 Maxima and can't get the heat to blow hot, it just blows cold air. (I just bought it last month after it sat for 8 months). The thermostat is fine as the engine doesn't overheat ever... And the ...

...button wasnt stuck. No A/C, just a constant hot air blowing at my foot, i cant drive for too long cause the heat is unbearable. Any suggestions? I checked the fuse and it seemed fine CHECK 10 AMP ...

maxima 2001 .Started running rough and stalled and smoking.Some say gaskets I am hoping it is the ignition coils there are many things that cause this, so it is best to have it scanned if light is on.

...2000 Nissan Maxima. The car over heats when in stop and go traffic. Temperatures run well when at high speeds. I changed the thermostat and filled the radiator and resevoir w/ coolant. There are two ...

cracked coolant reservoir, would this cause my car to overheat? My radiator has been replaced. the fluids all seem normal. Yet anytime I run the vehicle over 98 degrees F. And run the AC the care temp

2000 Nissan mis firing,, code reader shows codes: 0430; 0305; and 1320. Assuming its bank 2 cat convertor. Is this where i should start??? 430 is Oxygen sensor 0305 is misfire on cylinder 5 1320 is ...

...2000 maxima Yo can turn the check engine light off, as long as the car is running it will stay out but when you turn the car off and let it cool the light comes back on code p 1320 refers to ignition ...

...2000 maxima Can be caused by air in the engine cooling system, a clogged heater core, or a broken blend door. Does the temp change at all when you change the temp setting? If not, it's the blend door ...