Questions & Answers for: Maytag Neptune cause error code 33

...error code op The lid is open now, however when you close lid and press start button a op error code flash i This forum member?s solution is going in the right direction I?m going to give you a bit ...

...cause dc/UC errors. I call this a soft failure because most times the clutch spring is intact and the clutch roller bearings dry with a hint of rust that can be cleaned up with WD-40. A hard failure ...

...code). It is caused by a faulty magnetic reed switch. Apparently, the lid on these washers isn't completely watertight and allows water/moisture to get into the switch and corrode the wires and ...

...Error code for the FAV6800AW/FAV9800AW; You have lost signaling from the left lid lock to the control board. The lid magnet could be out of position here is a quick check to try. Raise the lid then ...

...error code such as dC or uC. What are the first two digits of your Serial Number it will be 10 thru 17 range. I?m an owner and will I?ll try to help?..Rich On FAV6800A's and FAV9800A(LCD Console) ...

...error code? The OP error code could be caused by a Lid Magnet out of position. To do a quick check with the lid open power up the washer. Do you have the OP error code showing? If so take a large ...

...error code, just "33". The load is still in the machine, with a tub of water still in it. If I unplug for several hours, the lock opens. Load and water still in the tub. I can program a new ...