Questions & Answers for: body nut Cars & Trucks

...nut and the faulty valve body,,where then your talking about $1500 give or take a few hundred depending on shop..but usually if it does it hot and cold its the nut loose and or both,but usually if it ...

...body and possibly input shaft nut need to be replaced. The valve body's booster valve is worn down and won't create pressure. Before it went completely out it slammed on the input shaft nut and ...

...nut and washer on the top of the valve body, that holds that long screw, there are no threads in the valve body so it will never get tight , to replace you need to remove the valve body or get mighty ...

...body out of the engine compartment. Unbolt the solenoid 'S' terminal nut and battery cable nut. Remove the starter motor mounting bolts, and lift the starter motor out of the manifold cavity. To ...

...nut -3 - loosely. . Attach inner tail lamp -4 - at body cut-out and make sure grip tabs - arrows - of clamp mounting rest against body cut-out . Slide clamp mounting - 1 - onto threaded pin of inner ...

...body. Take that nut off. This will release the outer body cover from the inner cover. Remove the outer body cover and then remove the two screws from the OUTSIDE of the body cover. Now follow the ...

...body bolt and remove control arm.torque control arm to crossmember nut and bolt 81 ft lbs, torque ball joint to steering knuckle bolt nut 44 ft lbs.torque crossmember to body bolt to 145 ft

...pipe. Install the heater pipe nut to the throttle body. Tighten the nut to 25 N.m (18 lb ft) . Connect the ETC electrical connector (1) to the throttle body (2). Install the air cleaner intake

...#2 bracket bolts=76lb-ft....#2 bracket nuts=148lb-ft.....lower control arm mount bolts=663lb-ft.....body mounts=597lb-ft....body mount nuts=35lb-ft...engine ...

...Jun 22, 2010 - lbs.) Strut Mount to Body Nut, 47 Nm (35 ft. lbs.) Strut to Knuckle Nut, 147 Nm (108 ft. 1 answer · Top answer: Tie Rod Inner to Gear 100 Nm (74 ft. lbs.)Tie Rod (Front) Lock Nut 64 ...