Questions & Answers for: PPI blown speaker

...speaker fuses that leave the LED on if blown. Check for continuity on the voice coils of both subs. Check for 12 volts on the remote turn on line from your receiver. If all of the above are good, the ...

AMP the short protection is coming on and is getting REALLY HOT REALLY FAST. If the amp gets hot or goes into protection with no input signal and no speakers/wires connected to the speaker terminals, ...

sub hook up to PPI D3000 amp I want to hook up one sub to a PPI amp but has four terminals what two terminals do I use I'm not familiar with this amplifier but in most cases, if a mono amp has more ...

...speaker wires from the amp. Also disconnect the signal cables. If the fuse blows without remote voltage applied, either the power supply transistors are blown or the B+ and ground are reversed (or ...

Hewlett Packard Compaq ProLiant ML370 G3 Server. I cannot turn on the ML370. I have problem on Power-On Password, lost password. How could I reset or over-write, or disable. I need to start machine ...

how to bridge a ppi amp Hello, The PCX-1500 is a single channel amp, it can't be bridged. I realize that it has two sets of speaker outputs but electrically it only has one output. The connections are

i need to know who is better for my cherokee sport 1999 ..!!! hi i have a doubt about 2 models of speakers for mi car.. who is better ? PC650c from ppi or MB QUART FSA-216 ???? thanks attn. leonardo ...

...sure it is clean and tight. It could be turned up to high for your sub to handle,you could have a blown voice coil on your sub...need more info on what you're running and how long you've had ...

amp turns on but doesent sound right pcx2125 amp turns on but doesent sound right, pcx2125 then it still has power but does have sound pcx 2125 its ur speakers

...blown speaker/fried vioce coil- push in on the speaker and it should push down about an inch with no resistance befopre bottoming out. if there is resistance, and/or it feels scratchy/rubbing when ...