...getting hot The thermal cutoff device blew and must be replaced. It acts like a fuse when the iron gets too hot. Thay are very cheap and it would be well worth replacing. Hope this was helpful. ...
Question about Black Decker Dualtemp Soldering Craft Iron CI500S
...black and decker soldering iron. it says it goes from 500/900F so i picked up some aluminum soldering rods workable at 700-750F But nothing happens. Iron is on highest setting and is hot. Any ...
hot Describe your Black & Decker Iron Problem You have a short somewhere in the cord. As this is a risk for fire, the Iron should either be taken for repair or replaced
...Black/Decker 2030 My iron also says clean, won't heat up. Real piece of trash and Black and Decker are a bunch of thieves in my eyes. I bet anything they know about these problems and sell the irons ...
...faceplate how do i clean the faceplate on a Black & Decker F67E? The build-up seems burned on and almost impossible to remove. first you get the iron hot, then you use a damp towel, and rub ...
...Black & Decker. In the meantime look for an appliance repair shop in your area and have the iron checked out. Most probably the cord has a bad contact within the iron. Iron consumes a lot of ...
Question about Black And Decker All Temp Steam Digital Iron D6000
Black and decker all temp steam iron stopped working while ironing and now it won't turn on. I've tried different outlets. The digital display does not come on and the iron does not get ...
Question about Black And Decker All Temp Steam Digital Iron D6000
black and decker steam iron #415 not hot enough - why black and decker steam iron #415 not hot enough the contact switch for heat control not get good contact or dirty need to clean.
Question about Black And Decker Classic Iron With Auto Off F67e
...black and decker classic iron from spitting out how water after I have used it for a while? It spits hot water after I have used it on Steam for a while. It is not over full I make sure of that. But ...
Question about Black And Decker Steam Advantage Iron
why when i turn on my black and decker steam iron it gets gets warm but will not hot? faulty thermostat it will cost more to repair than to replace
Usually answered in minutes!
202 Questions
119 Questions
145 Questions
74 Questions
82 Questions