Questions & Answers for: black bits drum washer

...black residue along the outside of the drum where the rollers ride. You will have to open the dryer cabinet to see the outside of the drum. Also, check the rear drum seal to make sure it is not ...

...black lines, almost as if they had been drawn by a marking pen and smudged a little bit. It happened to one load of clothes and then the washer was fine for 3 or 4 weeks before it happened again. Now ...

...bits over them Does your washer smell? Is your rubber door seal gungy too? If so then use 1/2 cup of Washing Soda Crystals (50p for a 1kg bag from most supermarkets) set washer to 60 degree wash and ...

...black rubber hose which connects the drum to the pump. Release the clip that holds the hose to the drum (be careful about any water that may still be in there) and then look inside the hose end . you ...

...a bit of the water. clothes are still soaked and water still left in drum. also there are black fleks -looks like old detergent left in bottom of washer machine wont spin just turns back and ...

when it stops. You need to clean the filter. Remove lower rear panel of washer. Locate and remove large black hose fastened to bottom of drum. Remove and clean filter inside hose. Reassemble and test

...Black spots on clothing. Ruined 2 loads.. Took the top and front bottom panels off. Do not see anything obvious that is missing. all 4 shocks in place,springs at the top holding drum in place. ...

...black part off that connects to the drum bit I found a ping pong size ball in there?? Is it supposed to be there as a ball valve effect when filling with water or not please? The ball is supposed to ...

...drum I notice there is quite a bit of black dust on and around the electric motor and was wondering if this is a normal sign of wear and tear or means the motor is nearing the end of its life. Prior ...

...black rubber bits on the floor. This could be the deteriorated parts of your black rubber coupler. Or just reach in and try to spin your washer drum by hand. It should be difficult to turn. If you ...