Question about 2000 Windstar
ford windstar 3.8 if i have right cylinder have replaced plug and wire and still getting cylinder one misfire #1 plug is the 1st plug on passenger side by firewall I have a 1996 ford wind star van. On
...ford winstar sel update to problem code p0305,cylinder 5 misfire detected,p0303 cylinder 3 misfire deteced p0174 bank 2 system too lean not sure what i'm looking for to fix thanks again i had ...
...ford windstar showing obd2 codes po303,po304,po305 and idiling ruff and wont run over 45 mph and has low miles, how do i fix it ,thanks sincerely mark might be the coil pack is bad, wires, plugs, o2 ...
Question about 2001 Windstar
ford windstar 2001 lx there are four code's i need info I have a ford windstar 2001 lx there are four code's i need info on #1- p1401 dpfe sensor #2- lean p0171 sensor bank 1 #3 lean 0174 sensor bank2
Cylinder 2 misfire - probably spark plug or wire Which cylinder is #2 on the 2003 3.8 Windstar? This should help: it is the middle one at the back of engine
2003 windstar sport you will need to check #2 cylinder compression. If good run engine and unplug the fuel injector for #2 to see if the idle changes. no change means bad injector. also check for good
Question about 2003 Windstar
...ford windstar 2003 hesitates during cold weather or wet conditions. But good during idle. Some time shows blinking engine light. This car is running fine in summers but it stalls or hasitates some ...
Question about 2003 Windstar
2003 ford windstar.3.8 engine/cylinder 3 misfire.where is cylinder 3? where is cylinder 3/on a 3.8 engine? Right rear, just in front of the passenger's knee (if USA) or driver's knee (if Britain).
where is cylinder .3 lots of miles/washed engine/now have misfire/plan on replacing wires-but where is cyl 3 cylinder 3 is at the back of the motor and on the drivers side last plug.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions