...strops there was a short in the wiring harness which was grounding out the altenator so i put in a new wiring harness and it works just fine now how to remove and replace a 2000 ford expedition ...
ford windstar wont start after replacing my battery, I can not get my van to start. All the lights/radio/locks work..but when I turn the key...nothing at all. TRY TO START THE VEHICLE IN NEUTRAL IF IT
2000 FORD WINDSTAR will not start 2000 FORD WINDSTAR 90K mi 3.8L Replaced neutral safety switch to stop an intermittent starting problem. Not it will not start at all. Change to a second switch and ...
...2000 ford windstar Removal & Installation Disconnect the negative battery cable. Raise and support the vehicle safely. NOTE When removing the hard shell connector at terminal -S-, grasp the ...
...2000 ford windstar radio works turn ignition on get nothing 3.8 eng Do you know what a starter sylonid is? it should be near the battery its round and has two or three post comeing off of it if you ...
2000 ford windstar radio works turn ignition on get nothing 3.8 eng. no power in engine fuse box compartment 1 relay warm & another clicks in fuse box under dash #1 Try starting the car in Neutral
Question about 2000 Windstar
...2000 ford windstar will strat but if you shut it off itwont start acts like the battery is dead but its brand new When this happened to mine, it turned out to be a failed starter. I would suggest you ...
Question about 2000 Windstar
...2000 ford windstar Replaced engine. Ran great 2 days. 3rd day started then stopped,Will not start. replaced ignition switch. have no gauges, power to ignition switch.Unhook batt.To stop lights etc It ...
2000 windstar with a 3.8 motor it cranks once then stops does not start. Battery checks out good, replaced the starter,tryed to start Van in netural,locked doors then unlocked with key. Steel will not
Question about 2000 Windstar
...2000 Windstar it sounds like the starter motor wants to engage but the motor doesn't move. I had the Battery checked and it's goodkicking out 1000 AMPS replaced the starter and still no cranking. I ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions