Don't know how to save and assign radio channels

Check in car owners book.


john kannas

follow coolant hoses to cylinder block thermostat in the housing.

Go to this site and look for the type of documentation that interests you.

1. 1. Press "MAN."
   
2. 2. Press "ENT/PGM" to put the scanner in programming mode. You will see PGM appears.
3. 3. Use the number keys to enter both the channel storage bank and the channel number you want to assign to a frequency.
4. 4. Press "MAN."
5. 5. Use the number keys to enter the frequency and don't forget decimal point.
6. 6. Press "ENT/PGM" to store the frequency into the channel.
7. 7. you just stored a frequency into a channel. Repeat steps above until you have your scanner programmed how you want.

• Hope this helps...

1. 1. Press "MAN."
   
2. 2. Press "ENT/PGM" to put the scanner in programming mode. You will see PGM appears.
3. 3. Use the number keys to enter both the channel storage bank and the channel number you want to assign to a frequency.
4. 4. Press "MAN."
5. 5. Use the number keys to enter the frequency and don't forget decimal point.
6. 6. Press "ENT/PGM" to store the frequency into the channel.
7. 7. you just stored a frequency into a channel. Repeat steps above until you have your scanner programmed how you want.

• Hope this helps.
  

ive got a 206 peogeot 2002 the radio displays 8 error can anyone help me on this?

poss number 4 injector due to water ingress in to wiring plug through o/s/f washer jet seal on the bonnet verry common on the 206

peugeot complicated their wiring alternately how old is the 206 if it is early then u need to connect both lives to permanent live on car if it is a late 206 then switch the lives

chek the regulator IC or Transistor.it's vey hot try to replace and install a heatsink for them.

Hi,

On a Motorola AXU Series (including the 4100):
1. To unlock, press the “D” button for about a second or until the circle is gone. The circle with the line thru is the keyboard lock indicator;
2. To change channel, you need to press either the arrow left or right in Normal Mode;
3. To change PL (assigned to a channel), don’t think this can be done by the user
4. To change Ch. 1 from 464.500 MHz (PL-67.0) to 463.525 (PL-136.5), don’t think this can also be done by the user.

Even the built-in Programming Mode Parameters do not have this option to change assigned frequencies and PLs. An external programming software using a PC may or may not allow this.

These radios came pre-loaded with its channels assigned with specific frequencies/PLs. As used in a Motorola AXU411, they are:

Channel Frequency PL
1 464.500 67.0
2 464.500 77.0
3 464.500 88.5
4 464.500 179.9
5 464.500 None
6 464.550 67.0
7 464.550 82.5
8 464.550 94.8
9 464.550 179.9
10 464.550 None

Hope this be of help/idea. Pls post back how things turned out or should you need additional information.

Good luck and kind regards.