Do you have a unlock code for a Toshiba SD-P1900 so i can make it multiregional?

Clean the disc using the Disc cleaner first.Hope it works!!

1. Power On
2. Open Tray
3. Press 9879 0 (0 = Multiregion, 1 = Region 1 etc etc)

I brought my dvd player to the Toshiba repair center. To be continued...

checkthe eye

i had this same problem, its likely a disconnected ribbon wire off the drive, One I plugged that in it read/spun the disk, now I just need to get the screen to stop being blank white heh. Good luck ^^

1. Power on the player.
2. Open the disk tray.
3. With the remote, enter the numbers 9 8 7 9 and
then press 0 (for region 0, or multiregion). A prompt
at the upper right hand corner of the start screen should tell you that the player has been set to region 0.
4. Close the disk tray.
5. Power off the player and then power it back on.

yea its possible but this may reouire you to use some dvd unlock firm ware you can check the link for some of the firmware http://www.dvd.reviewer.co.uk/info/multiregion/

1. Power on the player.
2. Open the disk tray.
3. With the remote, enter the numbers 9 8 7 9 and
then press 0 (for region 0, or multiregion). A prompt
at the upper right hand corner of the start screen should tell you that the player has been set to region 0.
4. Close the disk tray.
5. Power off the player and then power it back on.

this will require you downloading ddvd unlocking firmware check the link http://www.dvd.reviewer.co.uk/info/multiregion/

http://www.dvd.reviewer.co.uk/info/multiregion/