Hi do you need to turn on key to charge up battery on a wheeltech mobility scooter i just purchased with no manual thanks

Check the multi pin connector on tiller and where it connects under the seat between the batteries. Most common problem.

dealer price about 70.00

Hi, sounds like it's due a service , that should involve the brushes being inspected and replaced if required and making sure the brake is releasing okay...

Need more info then contact via my website...

Regards
Rob

www.gewizrepairs.co.uk

sound like you little scooter has a battery issue take to battery supply place along with your charger and have it tested.

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

The control seems to be the issue. I have rewired so many scooters. When you have power and it wont go, it is usually the control. If you cannot afford the part right away, you can rewire it or have it rewired direct

Hi,

That really sounds like the batteries need replacing but first check the battery connections.

Are you sure the battery charger is working correctly ?, can you try another charger ?

Regards
GeWiz.

Hi, I take it been taken then, do you get a error codes ?

see below


DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed below
develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
FLASH CODE CONDITION SOLUTION
! (1) Battery charge is low. Charge batteries as soon as possible.
! ! (2)
Batteries are too low to operate the
scooter.
Charge batteries.
! ! ! (3)
The scooter’s battery voltage is too
high to operate the scooter, or the
charger is still connected to charger
port.
Unplug charger and/or turn key off, then
back on again.
! ! ! ! (4) Current limit time out.
Turn the scooter off for a few minutes,
then turn your scooter back on.
! ! ! ! ! (5)
The manual freewheel lever is in the
(forward) freewheel position.
Remove the key from the key switch,
then push the manual freewheel lever to
the (rear) drive position, and restart your
scooter.
! ! ! ! ! ! (6)
Throttle control lever not at center
position at start up.
Return the throttle control lever to center
position, turn scooter off, then back on.
! ! ! ! ! ! ! (7) Speed pot error.
Contact your authorised Pride Dealer for
assistance.
! ! ! ! ! ! ! ! (8) Motor volts error.
Contact your authorised Pride Dealer for
assistance.
! ! ! ! ! ! ! ! ! (9) Other internal errors.
Contact your authorised Pride Dealer for


Regards
GeWiz.

If you use the scooter every day then plug the scooter in each night for 8-10 hours.

WHERE CAN I BUY CHEAP SPARES ESPECIALLY CIRCUIT BOARDS FOR A TRAVELEASE MOBILITY THREE WHEEL SCOOTER BOB.