90900237 is the serial number on my galaxy 2547

Hi Bill, something is wrong with the meter, have you hooked an external power meter to the unit? I assume you get around 12 watt on sideband and 5 on am (legal limit). I didn't pull up a service manual on the unit but generally there is an IC that feeds the meter, get a manual for part number and replace the IC, it's going to be obvious what IC it is with the manual as it will have the outputs going from it

www.cbtricks.com

1 one thousandth of a number and you are worried. now if it said 27.18350 instead of 27.1850 then you would be off frequency.but for that little bit its not even a problem

what problem you having which pin is which????

you have to buy a switch at radio shack that will let you add channels I think its a # 275-1386A .Then the fun begins . Heres where to go to get the rest of the information so if I print one thing wrong you can't yell that I told you to do it. These are the correct directions @ www.cbtricks.com look for galaxy 2547 and then look for freq conv and it all yours.

for upper ssb adjust L21 for 16.51250 mhz . adjust L22 for 16.50750 for lower ssb. you do have a frequency counter don't you ?

Normally, this radio will only work on CB frequencies. I suspect the radio has been modified to get channels below and above the regular 40. If so, the radio is no longer type-accepted by FCC. It is unlikely you would get into trouble using the radio.


....Don at NTCB, Inc.

if you have another radio put it right next to the 2547. turn on the monitor radio with no antenna on the same channel and key the 2547. if you can hear it the final transistor is bad. let me know if that worked

Is there a dial marked RX Gain? Does this radio have this feature?

M3ODQ

HI,
Sorry, the best I can do is recommend you to Galaxy as they are the sole repair station for your radio. ( according to them ). Here is the web link. Good Luck
Galaxy DX Radios -- Tech Support

Ed ( Radio Man )
NC Electronic
Mills, Wyoming
307-266-4675