Chronograph hands reset to wrong places

Please call citizen they are very nice will answer your questions.

put your finger nail under the crown and pull it out a bit ,then turn it to adjust the hands . when finished push it back in

its a solar watch meaning you have to completely charge the watch under artificial light for 24 hours or full sun for 6 hours

I assume that you do not have any instructions for this watch.
If you enter "www.citizen-signature.com/#/settings/" you should arrive at the page for your watch.

You can download the manual or look at sections.

The chronograph will only run for 59 minutes 59.95 seconds.

If you do not have a set on instructions for your watch, you can find one on their web site (citizen.com)

When there, click on "technical support" and the on "setting instructions" and fill in the number off the back of your watch.

If your watch was not stored where it could have light shining on it the LI battery would drain completely. There is a possible solution although it does not work all the time. It depends on how badly the battery has been allowed to drain.

Setup a lamp that will shine on a counter 24 hours a day and set your watch there. It helps if the lamp is about 1.5 - 2 feet above the watch. A 60 watt incand. lamp will work fine.

Leave your watch under this lamp for 3 - 4 days 24 hours a day. This will supply the solar cells with enough energy to recharge the battery and get it working again. If after this time it is still not working then the battery is just not going to accept a charge again or there is something else wrong that a watchmaker is going to have to fix for you.

Hope this helps.
Ken
Yellowstone Watch Inc.
www.yellowstonewatch.com

I think Its required Recharging capacitor
Put your watch under lamp light for 12 hours I hope that will solve the issue if not then capacitor need to be replace or watch need cleaning
hope this help
from
AmFix Jewelry & Watch Repair
203 N. LaSalle Street
Chicago, IL 60601
Ph: 312 641 7000
Email: [email protected]
Web: www.goamfix.com

You should be able to solve this by pulling out the Crown(the one with which you set your normal clock), Pull it out in the 2nd stand.
Then by pushing the 'start/stop' button --> you change the minutes.
By pushing the 'lap/reset' button --> you change the seconds

It worked for me, took me a few minutes to figure it out, i hope this saves others the time of doing that :p

try this

good morning ! to set the Eco Drive Skyhawk citizen watch,full the crown carefully wind it slowly until you reach the correct time after that push the crown back to normal possition, if the hand is turning back to the wrong time just press the button on the up side until the turn to the correct time,thank you ! god bless !...