My boat pulls hard to the right and no matter what I do it dose no help

hard wireing LEDs right now! (iceman) of GrandAmGT forms made the diagram!

Sorry about your dad,I do have a nitro boat 17dc the only buttons I would say they are is the bilge pump, airrater,running lights, or to bring up the motor. If this dose not help if you are close to a bass proshops they will help you get a book for your boat they do sell the nitro boats there.good luck

Please remove the usb cable and try to connect do you see the notification new hardware found if yes just check my computer dose the hard drive shows over there if yes and double click on it dose it open if yes and the hard drive is empty .
then go back right click on the hard drive check properties dose it show the empty and the full graphs if it shows full and dosnt show the drive letter.
then right click on the my computer icon on the desktop go to manage and diskmanage ment check the hard drive over ther dose it show its unformated or un initialized if no dose it have drive letter on it if no then right click on the drive and say change drive letter and assigned one letter like h or g and check in my computer now dose it appair.if still so try changing the usb cable may its defective.
if dosent detect at all could be your hard drive case so you can remove the hard drive from inside the case and connect it directly.in the computer if works backup your data abd return backthe hard drive in the case and if its still in gurentee return it to the service center.

The propellor can cause transverse thrust and the heavier the prop the greater the sideways pull. There are other factors like blade width and trailing edge cup. Is this the right prop for your boat? Some legs have a tension adjustment on them, and try that little fin again the other way,just one more time. Cheers Timo.

See if your rope pulley is opening up and allowing rope to double over on itself.When this happens the rope will wedge in pulley causing it to pull hard.

no. my 28 lb 3.5 tohatsu strains the pvc material that the tubes are made out of pretty well. the weight and thrust of the motor pulls pretty hard on these tiny little rubber "feet" glued to the tubes. I usually dont even run full throttle as it looks like i will pull the motor mount feet right off the tube. I couldn't imagine a bigger, heavier motor than what i am running working out well in the long run.
i have the intex mariner 4, btw.

If you are talking about the small tab under the cav. plate.Its job is to counteract the effect that the prop has on steering.Because the props. spin in one direction,they create a sideways pull on the motor due to the prop biting into the water and trying to pull all with it.2 motors on the 1 boat often have a different gearbox fitted,and one will spin in the opposite direction and this counteracts torque steer.To adjust yours,work out where you drive the boat most.Speed etc.Higher speeds have more effect.If it pulls right,adjust it left.One bit at a time.I think yours will have an allen key or hex screw above the tab.Loosen it,move the tab.Takes only minutes.I hope this helps

sounds like you are going to have to pull carbs off and clean jets also check tank and line for debries

is it stainless-not familiar with brand-but may well be corroded-try spraying with crc or similar-may take a few doses if corroding in shaft-get rough if needed-remove if possible so you can spray from both directions