To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:
Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.
SOURCE: how do i seperate the housing on a robot coupe processor
There are 4 rubber shoes on the bottom of the white or gray base. Twist & pull these out. With a TORX long shank screwdriver (nothing else works, trust me) there is a screw way down in each hole. After removing the screws a gentle but firm bump should loosen the base. If you ever need to replace the motor, on the top around the drive shaft you will see three round plugs/disks, remove them by prying up with a pocket knife (works best) this will give you access to the three motor bolts.
SOURCE: How do I assemble the Robot Coupe R 2 Ultra
Cindy,
Send me your e-mail & I will send you back an exploded view of your Robot-Coupe. It will give all the info needed. [email protected]
SOURCE: I have a Robot Coupe R2 food processor that quite
It just a long shaft phillips screwdriver. The screws are located under the foot pads. They just pull out and then there are the four screws.
SOURCE: Where in ireland can i purchase a blade of my
You may be able to get it here:
http://www.nisbets.ie/products/AdvancedSearch.asp?keyword=cl30&x=64&y=5&PageSize=50
The part isn't listed but if you ring them they might be able to order it in.
312 views
Usually answered in minutes!
×