Burberry horseferry quartz new watch not working

That means you have to change watch battery, as it is coming to the end of life (EOL).

i don't know but my dad does but he is only at home at night so i would take it in

To reset the time you pull the middle dial out a bit and twist it around to get to your desired hours and minutes. To reset the chronometer you need to press the start button until it stops and then the other button, known as a reset button.

pull crown out to second position then press start button till it goes to 12.00 then push crown back in ....job done......

I have seen other burberry watches and the back should pop out .
1- Locate a very small tab or recessed area on the edge of the back cover 2- Pull out the stem, which releases the back on some watches.3- Get a small flathead screwdriver it needs to be a thin inflexible tip 3- Very carefully slide the blade under the tiny metal protrusion on the back cover (or across the length of the recessed area, depending on which type of cover your watch has). 4- When you replace the cover, make sure you line up the stem slot on the cover with the stem of the watch. This information is on wiki: http://www.wikihow.com/Pry-off-a-Watch-Backing-Without-Proper-Tools

Great blog, thanks for sharing! http://www.ttoffice.co.uk/

mcdevito75 here, You may need to start your watch by pressing the MODE button. Most quartz watches will stop once you"ve changed the battery, of course the possibility is there that the watch quartz has burnt out also. See a small watch repair shop in your area.

mcdevito75 here, Sounds like you need a new quartz mechanism for your expensive watch, contact your watch company online, ----- Your watches name plus.com or check with any jeweler, watch repair in any large city in India. A new quartz mechanism and work is expensive depending on the value of your watch, it may pay just to replace the watch.

not often so . beleive you me from an avid fine watch collector . it's the batteries. hopt this helps.

Most likely the watch was damaged when the battery was installed. Quartz watches have fragile parts in them. The coils for instance are made of wire thinner than the hair on your head. It takes almost nothing to damage these wires and the coil. Dirt is a big problem. Since a quartz watch has no force behind the gear train the smallest particle of dirt can stop a quartz watch.

Either your watch will need a cleaning or damaged parts will need replacing.

A qualified watchmaker can do this work and get your watch back in working order for you.

Hope this helps,
Ken
Yellowstone Watch Inc.
www.yellowstonewatch.com