Poulan 446 poulan manual

Sorry we do not have the information on that.

Try choking it a little longer and it will warm up and should run

If the saw is brand new, take it into a service dealer for a carb adjustment (covered under the warranty). This sounds like it is your issue and unfortunately, you cannot correct it yourself because it requires a special tool.
As for you manual, it is located at the link below http://weborder.husqvarna.com/order_static/doc/NOUS/NOUS2006/NOUS2006_545137248.pdf

Try a new spark plug.Thanks for asking and I hope it helps

Hello,
a good starting point is the low speed screw at 1 3/4 turns and the high side at 1 1/2 turns. Hope it helps

Have you checked the spark plug to see if it is fouled? If thats not it, maybe the air filter is clogged. If that still isnt the case try some B-12 small engines carb cleaner. Use it generously.

you may need to disassamble the carb and clean it thoroughly.

its probably not getting any gas from the tank try putting your finger on the hole on the carberator and pull your finger should be wet if not take fuel line of the carburator and thenblow then take off the gas cap and blow through the hole on the gas tank it should flow freely throgh teh line to the carburator

Clean your gas tank start with some fresh gas.